Protocol options

t0 - Timeout of Connection establishment(s) - Time in seconds to receive attempt to establish TCP IP connection by a client. After this time closes the connection and reopens to rewait. Values allowed between 1 and 255.
t1 - Timeout of send OR test APDUs(s) -Time in maximum seconds acceptable by the slave to send or test APDUs, after receiving confirmation of the SEND OF START DT. Values allowed between 1 and 255.
t2 - Timeout for ack in case of no data(s)- Time in maximum seconds of waiting for the Customer of the arrival of a new information message, after having arrived any, for the customer to send an "acknowledgement" message of the receipt of the last received message. Values allowed between 1 and 255. And t2 should be less than t1.
t3 - Timeout for send test frames(s) - Time in maximum seconds of waiting for the arrival of some information message, and the TCP-IP connection is established. A TEST-FR message will then be sent. Values allowed between 1 and 255.
Max time to send analog changes (ms) - This time is set to the maximum wait for sending a message with changes in analog measures. If since you started the accumulation of measurements for the same message this time is exhausted before the arrival of the number of measures defined above, this module will send the message with the measures that have already arrived. This time per default is set at 3 seconds. If get analog changes by sampling mode is used ( see below), this is the time to be used as an interval between two samples.

Maximum Changes to send a message - To improve the performance of the communication module when sending changes to analog measures, you can set this number as the maximum of changes that must be accumulated to be sent in a single message, rather than sending a measure in each message. The number considered good is 30 measures, which is the default value. This accumulation is used when changes in measurements are received by the communication module, such as events. (AccessType with WriteEventEnable)

 Password for commands: To increase security when sending commands, typically initiated only by a change in the state of a tag, you can specify in client modules a 9-digit password for the command. Here in this server module must be specified the password used by this Server module to generate the command for the Client module that will actually send the command. This password must be the same as that used by the Client module that is the recipient of the command.

Logging Level - You can choose from this list the way the log works created by the communication module.

Get analog changes by sample - Alternatively to the way of receiving changes to tag values(by using AccessType with WriteEventEnable), you can choose the use of sampling mode, by the communication module, of changes that have occurred in tags.  In this mode, the current values are checked periodically against the last values sent. In this way the change is only considered, and the new value sent to the client, if the absolute difference between the current value and the last sent is greater than the Deadband attribute of the tag. For the use of this mode you must use the AccessType in table Points, for these measurement tags, with WriteEventEnable disabled. The time interval between each two checks will be the one defined in the parameter above, Max time to send analog changes (ms).

Settings

• Listening Port - Port number used to wait for connection. The use of the door is standardized 2404. In this implementation you can use other port numbers by changing the default.

• NodeConnections: Defines the maximum number of parallel requests that will be sent to each node (asynchronous communication)