Installation

To install the “WebGateway”, run the “InstallTWebGatewayService.exe” application. All the information for the WebGateway is in the TWebGatewayService.exe.config. This will create a windows service and all output will be sent to the windows event viewer. After any modification to the .config file, the windows service must be stopped and restarted.

Using additional ports

When using additional ports (ExtraCount parameter), you need to configure the TWebGatewayService.exe.config file, and then execute the WebGateway installation. The executable “InstallTWebGatewayService.exe” will verify the TWebGatewayService.exe.config and install the additional ports on the Windows routing table. After you make modifications to the related additional ports, you must follow the steps below: 

1. In the command prompt, run the application: InstallWebGateway /uninstall 

2. Modify the file: TWebGatewayService.exe.config

3. In the command prompt, run the application: InstallWebGateway

Available Parameters

The available WebGateway parameters can be found below:

LocalPort : WebGateway listening port. If you are ONLY using Windows Authentication, set the parameters to zero (0) and the port will not be opened

LocalPortWA: WebGateway listening port using Windows Authentication. If you are not using Windows Authentication, set the parameters to zero (0) and the port will not be opened

RemoteIP : Computer IP that runs the runtime server (TServer.exe)

RemotePort : “TServer.exe” listening port without Windows Authentication

RemotePortWA: “TServer.exe” listening port using Windows Authentication

WA:  Must use either RemotePort or RemotePortWA. It does not matter which port the data arrives in (LocalPort or LocalPortWA)

• True = Use only Remote Port WA

• False = Use only Remote Port

RuntimeUsersProject: [optional] Set which project (tproj) has the RuntimeUsers data table that will validate the users from SmartClient/RichClient

CheckRunTimeUsersWA: [optional] Set to validate the users from SmartClient/RichClient using Windows Authentication

• True = Enabled (Runtime Using Project parameter cannot be used when True)

• False = Disabled

TargetCF : [optional] This enables a project to be deployed in a Compact Framework environment (WindowsCE).

• True = Enabled

• False = Disabled

ExtraCount: [optional] Number of additional ports. These ports will only route the incoming data in the LocalPort<#> to the RemoteIP<#> and RemotePort<#>.

LocalPort2: WebGateway listening port. It must start with #2.

RemoteIP2:  Computer IP that is running the runtime service

RemotePort2: “TServer.exe” listening port

LocalPort3: WebGateway listening port

RemoteIP3: Computer IP that is running the runtime service

RemotePort3: “TServer.exe” listening port

RemoteIP<n>: Computer IP that is running the runtime service

RemotePort<n>: “TServer.exe” listening port

Starting the service

When the WebGateway service is started, log messages are in the Windows EventViewer.

Below is a message similar to one of the log messages:

First redirect :: LocalPort: 3101, RemoteIP: localhost, RemotePort: 3101,RemotePortWA: 3102
Extra Redirection Table:
Listen on ipv4: Connect to ipv4:
 
Address  Port   Address         Port
-------- ------ --------------- -------
0.0.0.0  3100   192.168.80.129  3100
0.0.0.0  3102   192.168.80.129  3101